TECHNICAL DATA SHEET
1/3
R114.205.000
STRAIGHT JACK CLAMP TYPE
Series : SMB
CABLE 2.6/50+75 S
All dimensions are in mm. . pn
. ao
COMPONENTS BODY CENTER CONTACT OUTER CONTACT INSULATOR GASKET OTHERS PARTS -
MATERIALS BRASS BRASS PTFE BRASS -
PLATINGS (µm) GOLD 0.2 OVER NICKEL 2 GOLD 1.3 OVER NICKEL 2 -
GOLD 0.2 OVER NICKEL 2 -
Issue : 0216 C In the effort to improve our products, we reserve the right to make changes judged to be necessary.
TECHNICAL DATA SHEET
2/3
R114.205.000
STRAIGHT JACK CLAMP TYPE
Series : SMB
CABLE 2.6/50+75 S
PACKAGING Standard 100
SPECIFICATION
Unit ‘W’ option
Other Contact us
CABLE ASSEMBLY ELECTRICAL CHARACTERISTICS Impedance Frequency VSWR 1.25 + Insertion loss RF leakage -( Voltage rating Dielectric withstanding voltage Insulation resistance
50 0-4 0.040 0.25 57 335 1000 1000
Ω GHz x F(GHz) Maxi
a
b
c
d
e
f
mm
2.50
0.00
4.50
4.50
1.20
0.00
√F(GHz) dB Maxi - F(GHz)) dB mini
Assembly instruction :
Veff Maxi Veff mini MΩ mini
Recommended cable(s) RG 188 RG 187 KX 22A RG 179 RG 316
MECHANICAL CHARACTERISTICS Center contact retention Axial force – Mating end Axial force – Opposite end Torque
Stripping
Cable retention - pull off - torque
10 N mini 10 N mini NA N.cm mini
TOOLING Part Number .
Recommended torque Mating Panel nut Clamp nut A/F clamp nut
NA NA 40 5.000
Mating life Weight
500 Cycles mini 2.390 g
N.cm N.cm N.cm mm
Description .
Hexagon .
OTHERS CHARACTERISTICS -
ENVIRONMENTAL Operating temperature Hermetic seal Panel leakage
110 N mini NA N.cm
-65/+165 ° C NA Atm.cm3/s NA
Issue : 0216 C In the effort to improve our products, we reserve the right to make changes judged to be necessary.
TECHNICAL DATA SHEET
R114.205.000
STRAIGHT JACK CLAMP TYPE
Series : SMB
CABLE 2.6/50+75 S Flat gasket Back nut
Clamp braid Washer 2
3/3
Center contact body Insulator 1 Insulator 2
Washer 1
1
3
Slide the back nut,the washer 1,the flat gasket,the washer 2 onto the cable. Strip the cable. Cut 2 slots in the jacket if necessary.
Slide the first insulator. Slide the center contact and solder. Slide the second insulator
Solder
2 slots at 180°
2 Slide the clamp braid sleeve. Cut the braid flush with the clamp braid sleeve. Strip off the diélectric.
4 Screw sub-assembly into the connector body with the adapted wrench. Recommended coupling torque ( see connector TDS ).
Hex. : see connector TDS Issue : 0216 C In the effort to improve our products, we reserve the right to make changes judged to be necessary.
