DeWalt DW920 Motor Replacement

ID de guía: 61444 - Borrador: 2016-05-17

DeWalt DW920 Motor Replacement If your battery is charging but the drill still does not run when the trigger is pulled, the motor has most likely died. This guide will show step-by-step how to replace the motor.

Escrito por: Stephen Rada

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 1 de 5

DeWalt DW920 Motor Replacement

ID de guía: 61444 - Borrador: 2016-05-17

HERRAMIENTAS: T10 Torx Screwdriver (1) H5.0 bit Driver (2) Soldering Iron (1)

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 2 de 5

DeWalt DW920 Motor Replacement

ID de guía: 61444 - Borrador: 2016-05-17

Paso 1 — Disassembly 

Use a T-10 Torx bit screwdriver to take out the 4 screws shown.



Use 2 H-5.0 bit drivers to take out the main bolt and head.



Note: there will be blue locktite on the tread

Paso 2

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 3 de 5

DeWalt DW920 Motor Replacement

ID de guía: 61444 - Borrador: 2016-05-17

Paso 3 

Pull apart 2 halves of the handle.



Gently lift the motor and trigger mechanism out from the frame of the drill.

Paso 4 — Motor

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 4 de 5

DeWalt DW920 Motor Replacement

ID de guía: 61444 - Borrador: 2016-05-17

Paso 5 

Locate where the motor assembly is attached to the trigger mechanism and carefully detach the wires at their solder points.



Solder the new motor assembly wires to the trigger mechanism in the same fashion that the old motor was.



Note: Take care of where each wire connects because the wires must be soldered to the correct places on the trigger mechanism for the motor to run.

Paso 6

To reassemble your device, follow these instructions in reverse order. La versión más reciente de este documento fue generada en 2019-07-29 12:43:22 AM .

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 5 de 5