Crydom D06D100 Datasheet - Octopart

Control Voltage. 60A. 80A. 100A. 3.5-32 VDC. D06D60. D06D80. D06D100. OUTPUT ... Thermal Resistance Junction to Case (Rjc) [°C/W]. 0.6. 0.47. 0.32.
620KB Größe 1 Downloads 201 Ansichten
D06D Series • MOSFET output • Ratings from 60A to 100A @ 60 VDC • DC control • Relays are easily paralleled for higher-current applications

PRODUCT SELECTION Control Voltage 3.5-32 VDC

60A

80A

100A

D06D60

D06D80

D06D100

OUTPUT SPECIFICATIONS (1) Description Operating Voltage Range Maximum Off-State Leakage Current @ Rated Voltage [mA] Maximum On-State Resistance @ Rated Current [RDS-ON][Ohms] Maximum Load Current (3) [Adc] Minimum Load Current [mA] Maximum Surge Current [Adc] (10ms) Maximum On-State Voltage Drop @ Rated Current [Vdc] Thermal Resistance Junction to Case (Rjc) [°C/W]

0-60 VDC 0.1 0.010 60 5 180 0.6 0.6

0-60 VDC 0.2 0.008 80 5 220 0.7 0.47

0-60 VDC 0.3 0.005 100 5 270 0.5 0.32

INPUT SPECIFICATIONS (1) Description

DC Control

Control Voltage Range Minimum Turn-On Voltage Minimum Turn-Off Voltage Maximum Input Current Nominal Input Impedance Maximum Turn-On Time [μsec] Maximum Turn-Off Time [msec]

3.5-32 VDC 3.5 VDC 1.0 VDC 1.6 mA (5 VDC), 28 mA (32 VDC) See Note 4 300 1.0

GENERAL SPECIFICATIONS Description Dielectric Strength, Input/Output/Base (50/60Hz) Minimum Insulation Resistance (@ 500 V DC) Maximum Capacitance, Input/Output Ambient Operating Temperature Range Ambient Storage Temperature Range Weight (typical) Encapsulation Terminals Recommended Terminal Screw Torque Range:

Parameters 2500 Vrms 109 Ohm 50 pF -30 to 80°C -40 to 125 °C 3.0 oz (86.5g) Thermally conductive Epoxy Screws and Saddle Clamps Furnished, Unmounted 6-32 Screws - 10 in lbs. 8-32 and 10-32 Screws -20 in. lbs. (Screws dry without grase)

GENERAL NOTES 1) 2) 3) 4)

All parameters at 25°C unless otherwise specified. Dielectric strength and insulation resistance are measured between input and output. Heat sinking required, see derating curves. Input circuitry incorporates active current limiter

MECHANICAL SPECIFICATIONS

THERMAL DERATE INFORMATION

WIRING DIAGRAM

AGENCY APPROVALS Rev. 052009

ANNEX - ENVIROMENTAL INFORMATION