Sony FDL-220R Watchman Antenna Replacement

Grasp the entire back half of the Watchman's casing.. Snap off the casing from the bottom of the device.. Gently pull off entire back casing.. Buttons may fall ...
1MB Größe 4 Downloads 249 Ansichten
Sony FDL-220R Watchman Antenna Replacement

Sony FDL-220R Watchman Antenna Replacement The antenna on the Sony FDL-220R Watchman is also a neck strap (the "straptenna"), and can easily detach under a hard pull. This guide will show how to reattach or replace an antenna that has been broken off.

Geschrieben von: Sam Putnam

© iFixit — CC BY-NC-SA

de.iFixit.com

Seite 1 von 6

Sony FDL-220R Watchman Antenna Replacement

EINLEITUNG This guide will outline how to disassemble and reattach or replace the Sony FDL-220R Watchman antenna. Steps include basic disassembly of the Sony FDL-220R Watchman, and tools include a Phillips #00 Screwdriver and a Spudger.

WERKZEUGE: Phillips #00 Screwdriver (1) Spudger (1)

© iFixit — CC BY-NC-SA

de.iFixit.com

Seite 2 von 6

Sony FDL-220R Watchman Antenna Replacement

Schritt 1 — Remove battery cover and batteries



Press down on the textured area and push towards the bottom of the device.



Gently remove the battery cover.



Remove the three AA batteries.

© iFixit — CC BY-NC-SA

de.iFixit.com

Seite 3 von 6

Sony FDL-220R Watchman Antenna Replacement

Schritt 2 — Remove screws



Locate the five 5x11mm screws surrounding the battery compartment.



Remove screws with a Phillips #00 screwdriver.

© iFixit — CC BY-NC-SA

de.iFixit.com

Seite 4 von 6

Sony FDL-220R Watchman Antenna Replacement

Schritt 3 — Remove back casing



Grasp the entire back half of the Watchman's casing.



Snap off the casing from the bottom of the device.



Gently pull off entire back casing.

 Buttons may fall out upon opening casing. See the

© iFixit — CC BY-NC-SA

button replacement guide to fix buttons.

de.iFixit.com

Seite 5 von 6

Sony FDL-220R Watchman Antenna Replacement

Schritt 4 — Reattach antenna



Locate the two metal tabs which are meant to hold the antenna in place.



Pry back the metal tabs with a spudger.



Hook the antenna into the metal tab.



Ensure that the antenna is fully enclosed in the metal tab.

To reassemble your device, follow these instructions in reverse order. Dieses Dokument wurde zuletzt angelegt am 2017-10-12 02:49:40 PM.

© iFixit — CC BY-NC-SA

de.iFixit.com

Seite 6 von 6