Fujifilm FinePix S8200 LCD Screen Replacement

29.09.2017 - EINFÜHRUNG. Lots of things could cause your LCD screen to need replacing. Here's how to do it. Fujifilm FinePix S8200 LCD Screen Replacement. © iFixit — CC BY-NC-SA de.iFixit.com. Seite 2 von 6 ...
2MB Größe 1 Downloads 301 Ansichten
Fujifilm FinePix S8200 LCD Screen Replacement

Fujifilm FinePix S8200 LCD Screen Replacement This guide shows how to replace the LCD screen on the Fujifilm FinePix S8200.

Geschrieben von: Joseph Kelley

© iFixit — CC BY-NC-SA

de.iFixit.com

Seite 1 von 6

Fujifilm FinePix S8200 LCD Screen Replacement

EINFÜHRUNG Lots of things could cause your LCD screen to need replacing. Here's how to do it.

© iFixit — CC BY-NC-SA

de.iFixit.com

Seite 2 von 6

Fujifilm FinePix S8200 LCD Screen Replacement

Schritt 1 — Batteries 

Turn the camera upside down so you can access the battery chamber.

 Make sure that the camera is powered off before opening the battery chamber. Not doing so could damage your memory card.

© iFixit — CC BY-NC-SA

de.iFixit.com

Seite 3 von 6

Fujifilm FinePix S8200 LCD Screen Replacement

Schritt 2 

Push the battery chamber latch in the direction of the front of the camera. Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.



With the battery chamber open, remove the old batteries.

Schritt 3

 When replacing the batteries, remember that the battery orientation is shown by the + and marks. Each mark indicates which side of the battery faces up in the chamber.

© iFixit — CC BY-NC-SA

de.iFixit.com

Seite 4 von 6

Fujifilm FinePix S8200 LCD Screen Replacement

Schritt 4 — Rear Housing Cover



Remove the 4mm Phillips #00 screws from the sides and bottom of the camera.

Schritt 5



Carefully pry away the rear housing cover with the plastic opening tool.

© iFixit — CC BY-NC-SA

de.iFixit.com

Seite 5 von 6

Fujifilm FinePix S8200 LCD Screen Replacement

Schritt 6 

Remove the rear housing cover by carefully pulling it away from the camera.

Schritt 7 — LCD Screen



Fold back the LCD screen with the plastic opening tool.



Remove the cable coming from the LCD screen that goes into the motherboard.

To reassemble your device, follow these instructions in reverse order. © iFixit — CC BY-NC-SA

de.iFixit.com

Seite 6 von 6

Dieses Dokument wurde zuletzt angelegt am 2017-09-29 11:30:46 PM.